Troubleshooting
· Check on/off switch on back side of station unit.
· Check power source or contact your distributor.
· Touch the LCD screen with your finger.
· Check if power supply is connected and power
switch is on.
· Reset the power button.
· Check if the scope unit and station unit are connected
properly.
· Connect the 2
nd
scope unit to the station unit after
connecting the 1
st
scope unit first using the
connection cable.
· Check if the focus interface is inactive or not.
· Move the focus knob to the opposite side.
· Re-optimize the brightness and the exposure value.
· Reset the power button
· Swipe the stage with cotton swab carefully.
· Eliminate any dust on the culture dish.
· Check for and remove any condensation on the lid
of the culture dish.
· Warm up the instrument for 1 hour before monitoring
(The power should be on when warming up the
instrument.).
· Cell culture flask should be wetted by the culture
media before making a movie.
· Eliminate any dust on the culture dish.
· Remove any condensation on the lid of the culture dish.
· To prevent any problem such as shaking of culture
dish or inflowing light, pay special attention when you
open or close an incubator door during monitoring.
· Check the minimum interval (Refer to page 24).
· Check available volume of the hard disk.
Installation
JuLI™ FL does not power
up
LCD screen is black
Focusing and Monitoring
menu are not activated
Get an error message while
connecting the 2
nd
scope
unit
Focus
Focus knob or focus
interface doesn’t work
Monitoring
Poor image
(Too dark and too bright)
Dirty image
Time-lapse images become
dark or bright
Can’t set the interval
Problem for saving movie file
JuLI
TM
FL, Fluorescence Cell History Recorder ©2013 NanoEnTek Inc.
65
