© by N&W GLOBAL VENDING S. p. A.
10
09 2010 H 83127 00
e
spresso
uNiT
Whenever you fill or at least once a week, it is recom
-
mended to remove any powder residue from the external
parts of the coffee unit, in particular in the capsule load
area.
attention!
It is absolutely necessary to reassemble the cover
before setting the machine at work once again (see
figure 12).
c
leaNiNg
THe
capsule
DispeNser
clean the machine once a month or more frequently if
required by operating conditions by acting as follows:
- disconnect the machine from the power mains;
- remove the capsule container by holding it by the sepa-
rator ring and by lifting it slightly upwards; pay attention
to the capsules that might come out of the container;
- remove the capsule selection disk; pay attention to col-
lect the capsules inside the disk;
- remove the coffee powder and any other residue by us-
ing a vacuum cleaner or a brush;
- clean the surfaces of the selection disk and the dis-
charge ring base by using a piece of cloth.
to reassemble, act as follows:
Make sure that the handle bearing is outside the area of
interference with the capsule selection disk. If neces-
sary, align the machine.
Make sure that the handle bearing is outside the area of
interference with the capsule selection disk. If neces-
sary, align the machine. act manually by rotating it
gently on the drive pin of the agitator;
- the selection disk shall be positioned so that a capsule
shift cell is aligned to the discharge hole. after having
positioned the disk, slightly press to insert it into its
seat;
- replace the separator ring;
- replace the capsule container;
- replace the agitator / spreader;
- load the capsules;
- close the door and make a test selection. the position-
ing chamber is emptied and the search device auto-
matically repositioned.
- wait until the capsule search and shift device stops; the
display will show the “running” message.
- act manually by rotating it gently on the drive pin of the
agitator;
- the selection disk shall be positioned so that a capsule
shift cell is aligned to the discharge hole. after having
positioned the disk, slightly press to insert it into its
seat;
- replace the separator ring;
- replace the capsule container;
- replace the agitator / spreader;
- load the capsules;
- close the door and make a test selection. the position-
ing chamber is emptied and the search device auto-
matically repositioned;
- wait until the capsule search and shift device stops; the
display will show the “running” message.
Fig. 12
capsule container
1-
agitator
2-
capsule selection disk
3-
handle bearing
4-
drive pin
5-
discharge ring base
6-
discharge hole
7-
capsule shift cell
8-
separator ring
9-
weight spreader
10-
Summary of Contents for Canto LB 3600
