NANAWALL CSW75 OWNER’S MANUAL
14
MAINTENANCE CHECK LIST
Following recommended check list of Maintenance Notes
to be carried out on a regular basis by a maintenance
person:
a. Clean upper track
b. Check height adjustment and setting
of each panel
c. Check if all panel end caps are in place
and fixed
d. Check if all carriages can be moved easily
e. Check if counter nuts on carriages are
adequately fastened
f. Check if hinges can be moved easily; lubricate
if necessary
g. Check if pin carriers in pivot panels are
in the right position
h. Ensure that the lower locks can be moved
easily; lubricate if necessary
i.
Check if floor sockets, pivot points and door
closers are adequately fastened to the floor
j.
Remove any dirt from the floor sockets, pivot
points and bottom door closers
k. Ensure that any lock and profile cylinder can be
moved easily
GLASS INSTALLATION AND GLAZING
This section applies only if you need to install glass for
any reason. Proper glass installation is critical, as, with the
NanaWall Folding Center Pivot Frameless System, glass is
a structural part of the panel.
Glass, with appropriate dimensions, thickness and
specifications will be needed. Depending on the model,
widths of frameless all glass panels may not be equal. Ask
NanaWall for the glass dimensions. Please note that glass
is required to be safety glass – either fully tempered or
laminated as specified for a particular order. Check with
all applicable codes and regulations.
Glass shall meet the current requirements of ASTM C
1306 “Standard Specifications for Flat Glass” for quality,
thickness and dimensional tolerances. Tempered float
glass shall meet the current requirements of ASTM C
1048 “Standard Specifications for Heat-Treated Flat
Glass - Kind HS, Kind FT Coated and Uncoated Glass.”
All tempered glass shall have a permanent logo, which
signifies Safety Commission 16 CFR-1201 and the safety
glass test requirements of ANSI Z 97.1 (current editions)
or other equivalent safety standards.
Follow all proper applicable glass installation and glazing
techniques as recommended in the Flat Glass Marketing
Association (FGMA) “Glazing Manual” and “Sealant
Manual”. Always use suction cups to shift glass within an
opening. The panels would need to be removed from the
opening to install the glass. Panels can be laid flat on
sawhorses.
Please contact NanaWall before you replace a glass
pane in order to get the right material and instructions
to glaze the panel!
