7-5 Brake Accelerator Pedal Assembly
NOTE: LUCKY WILD uses
a
HAPP CONTROLS
pedal
mechanism.
NOTE: Numbers shown are Happ Controls Part Numbers.
Illustration
DUAL PEDAL ASSEMBLY
7-5-l Replacing the Brake Accelerator Pedal Assembly
(1) Open the mar door and remove the connector to the pedal assembly.
(2) The Pedal Assembly may now be removed from the front.
(3) Using the security wrench, remove the four (4) security bolts that
mount the pedal assembly to the cabinet, then the pedal assembly can
be taken out from the front.
7-5-2 Replacing the Pedal Assembly Potentiometer
(1) Remove the pedal assembly. (Ref. 7-5-l)
(2) Remove the two (2) cap bolts that hold the potentiometer brackets.
(3) Take out the
potentiometer bracket including the gear.
*
When replacing the brake pedal potentiometer, remove four (4) nuts,
remove the brake unit, then follow procedures (2) and (3) above.
NOTE: *
*
Since the potentiometer has a built-in stop, be sure that
the stop won’t over travel when reassembled.
When replacing, set the potentiometer to have a value of
(mid range).
NOTE: Whenever the pedal assembly or potentiometers are replaced, the
Initializing Controls procedure (Section 5-6) must be completed.
16
Summary of Contents for LUCKY & WILD
