7-4 Steering Assembly
NOTE: LUCKY
uses a HAPP CONTROLS
steering
mechanism.
NOTE: Numbers shown are Happ Controls
Numbers.
Illustration
7-3.
STEERING ASSEMBLY
741 Replacing the Steering Assembly
(1) Remove the steering wheel by taking off the center cap and removing
the three (3) bolts.
(2) Using the security wrench, remove all four (4) bolts that hold the
plastic cover of the steering assembly.
(3) Open the control panel. (Ref. 7-3)
(4) Disconnect the harness from the steering assembly.
(5) Remove the nuts that hold the steering assembly to take out the steer-
ing assembly.
742 Replacing the Steering Assembly Potentiometer
(1) Open Control Panel. (Ref. 7-3)
(2) Remove the
(2) screws that hold the potentiometer brackets.
(3) Take out the entire potentiometer bracket including the gear.
NOTE: * Since the potentiometer has a built-in stop, be sure that
the stop won’t over travel when reassembled.
When replacing, set the potentiometer to have a value of
(mid range).
Whenever the steering assembly or potentiometers are replaced,
Initializing Controls procedure (Section 5-6) must be completed.
15
Summary of Contents for LUCKY & WILD
