7.
MAINTENANCE
CAUTION
1
SURE TO UNPLUG THE
AC
POWER BEFORE
CONDUCTING ANY MAINTENANCE PROCEDURES
7 - l
Replacing the Gun Assembly
2.
3.
4.
6.
base covers (L) and (R). Carefully
the fwo covers apart to remove.
Remove the two (2) cap screw bolts
12) that secure the cover holder to
the gun on the side opposite the gun base. Remove the cover holder.
Carefully disconnect the
(Amp) connector.
Remove the two (2) bolts holding the gun base to the dashboard.
Tilt and lift the gun base to remove the gun assembly.
To reinstall, hook the gun base on the screw protruding from the dashboard,
and reinstall the bolts. Install the gun base covers being careful to make
sure that the slide plate is above the slide table.
NOTE:
Whenever tbe gun assembly or gun potentiometer are replaced, the
gun adjustment procedure (Section 5-5) must be completed.
Illustration
7-1, REPLACING THE GUN ASSEMBLY
13
Summary of Contents for LUCKY & WILD
