5-5 Gun Adjustments
For normal game play, the guns must be adjusted whenever replacing the game
PCB, gun assembly or potentiometers, by following the procedure described
below:
1. Open the coin door.
2. Set the test switch to “ON”. Press the service switch several times until
Screen 1 (below) is displayed.
3.
4.
5.
SCREEN
SCREEN 2
GUN
SCREENS
The Player one
gun MUST be adjusted
Calibration is performed
as follows:
a. Rotate the left gun
until it is aligned with the upper left
icon. Be
careful not to align the gun higher than the
icon as this will cause the
gun to move abnormally during game play.
b. When the gun and
are aligned, squeeze the nigger. This will cause
Screen 2 to be displayed.
c. Rotate the left gun
until it is aligned with the lower right
icon.
Be careful not to align the gun lower than the
icon as this will cause
the gun to move abnormally during game play. When properly aligned,
squeeze the trigger. This completes adjustment for the left gun.
Adjust the right gun (2P) in the same manner following steps 3a through
above. When “OK ADJUSTMENT END” is displayed on the screen, the
proper gun
has been completed.
Press the service switch to move to the next test screen, or return the test
switch to “OFF’ to return to the attract mode.
NOTE: If gun’s aim appears to be improper during game play, adjust the
gun(s) by following the procedure above.
9
Summary of Contents for LUCKY & WILD
