NAMCO AquaJet, Operator'S Manual

Page: 28 / 57

Page 31
7 INITIALIZATION
Adjustments When Replacing Parts (Initialization)
The following adjustments should always be performed after replacing the
game PC board, ROM, or Control Pots.
The game will not operate correctly if these adjustments are not made.
a) Ensure that Control Handle assembly and Ride assembly are in the
neutral stand-by position.
b) Slide the test switch “ON” while pressing the service switch. The following
screen will be displayed on the monitor.
VOLUME INITIALIZE
TEST SW ON
COIN SW OFF
SERVICE SW
OFF
START BUTTON OFF
ACCEL LEVER 0000 0000
SWING 0000 0000 CENTRE
HANDLE POLE
0000 0000 UP
START:HANDLE POLE ADJUST
c) At this time the Ride assembly and Accelerator lever are initialized.
d) Press the start button to initialize the Control Arm. The following screen
will be displayed.
e) Move the Control Arm UP and DOWN through its full range of movement.
This motion will be registered as the motion range of the Control Arm.
f) Slide the test switch “OFF” to return to normal game mode.
HANDLE POLE ADJUST
UP DOWN
HANDLE POLE 0000 0000
PLEASE MAKE HANDLE POLE
UPDOWN TO ADJUST!