7
OK
STARTUP | PROGRAMMING THE SYSTEM
Typically all new pool installations will not contain copper. The system will run for
one hour per one thousand litres for the initial start-up only to achieve correct
copper levels. Time remaining will display on the screen for the customer and the
pool can be used immediately.
For retrofitting existing pools, check copper levels prior to starting the system.
If copper is existing at adequate levels of 0.2ppm – 0.5ppm, choose YES.
Did you know?
The volume of water in the pool determines the run times of the system for both
initial startup (injection of copper) and automatically sets the pump run times on
a daily basis.
Did you know?
Programming the Naked System is completed in 6 simple steps using the following
controls which are located in the centre of the Control Unit keypad :
Set the Clock’s Time of Day.
Choose if you added Salt or Minerals.
Choose whether there is existing copper in the pool.
STEP 1
STEP 3
STEP 2
Set the Pool Size (Litres).
STEP 4
The digital display on the Control Unit will typically explain each step and how to
adjust or save the desired setting.
Did you know?
INCREASE SETTING
ENTER
SAVE
NEXT
DECREASE SETTING
BACK
EXIT
