Nakayama MB9000 CLASSIC, Instructions Manual

Page: 5 / 56

EN
STARTING THE ENGINE
Caution: Ensure that the gear lever is in the neutral position.
• Start the engine and let it run without load for about 2-3 minutes at idle speed.
• Check whether the engine is operating normally. In case it is found to be running abnormally, stop the engine and inspect it for malfunctioning parts or other
damage.
8. Clutch cable (Images 16-17): Loosen the nut located on the regulating screw to loosen the cable as much as possible.
Screw the regulating screw (1) located on the clutch arm (2) and ensure it is tightened securely. Then, press the clutch arm and insert the cable in the hole
as shown in image 17.
Unscrew the clutch regulator until the clearance of the clutch cable is reduced to less than two millimetres and then tighten the nut.
9. Reverse gear cable (Image 18): Loosen the nut located on the regulating screw.
Tighten the regulator screw securely.
Insert the cylindrical part of the reverse gear cable into reverse gear arm.
Push the reverse gear arm upwards and pass the cable and the cable casing through the slot of the regulator.
Unscrew the reverse gear regulator until the clearance is less than two millimetres and then tighten the nut.
10. Final check and filling oil (Images 19-21): Check that all screws and fasteners are correctly fitted and that they are tightened securely.
Check that the handles are correctly positioned. If they are not in the correct position, adjust them.
Set the gear lever in the neutral position.
In order for the gearbox to be lubricated, valvoline 80-90 needs to be added. Fill the gearbox until the oil reaches the upper
level indicated at the top part of the gearbox.
Filling oil: We recommend using SAE20-50 or SAE 30 oil for diesel engines.
Place the engine on a flat surface and fill the oil into the engine hole (cap [1] in image 20). The quantity should be 1750ml.
Check the oil level from the oil gauge. Check the oil level before each use.
Add oil in the air filter under the protector until it covers the hole (1) shown in image 21. Add approximately 150ml of oil.
Warning: The oil level must always be at the upper limit. (Figure 3)
Upper limit
Lower limit
Fig. 3
OPERATION
• Pull the clutch with your left hand.
• Pull the gear lever backwards with your right hand and ensure that it is set in the low gear position.
• Slowly release the clutch. The tiller will now run in low gear.
Gear shifting - Low gear
• Pull the clutch with your left hand.
• Pull the gear lever backwards with your right hand and ensure that it is set in the high gear position.
• Slowly release the clutch. The tiller will now run in high gear.
Gear shifting - High gear
• Pull the clutch with your left hand.
• Shift the gear lever to the neutral position.
• Slowly release the clutch. The tiller will now move in reverse gear.
Gear shifting - Reverse gear
Shifting gears
• In order to correctly change gear while operating the machine, let the machine slow down and then pull the clutch. The gears should only be changed when
the machine is stopped.
Changing direction
• In order to change direction, turn the handle left or right.
Stopping operation
• Hold the clutch with your left hand and, after setting the gear lever to the neutral position, release the clutch to stop the machine.
5
WWW.NIKOLAOUTOOLS.GR