Page | 32
The motion editor is an app that is used to adjust the motion parameters on the fly. Setting these values will
update the motion settings for every font of Spark Color 2™, as well as the sensitivity of this editing mode.
Once in the Motion Editor, press the main button to enter editing. From there the following actions are possible.
Entry
Label
Action
Description
Aux Button
AUX +/-
Press
Increments the current motion parameter by 10.
Aux Button
AUX +/-
Hold
Plays the instructions.
Swing saber
NA
Swing
Plays the swing sound; swinging around the saber gets a feel
for the current motion settings.
Rotate saber
NA
Rotate
Plays the Dual Phase™ sound (no color change). Performing
this motion gets a feel for the current settings.
Hit saber/Blade CS
Clash
Plays the clash sound. Performing the clash gets a feel for the
current motion settings.
Rotate saber
NA
Hold Aux
Advances to the next motion parameter to edit. Parameters
are Swing Threshold, Slash Threshold, Clash Threshold, GyroX
Threshold, and GyroYX Threshold respectively.
Swing saber
NA
Swing +
Hold Aux
Same behavior as rotating the saber and holding Aux; see
above.
Hit saber/Blade NA
Clash +
Hold Aux
Same behavior as rotating the saber and holding Aux; see
above.
Main Button
MAIN+/-
Hold/Unlatch Holding or unlatching the main button will cause the
retraction sound to play and all changes made to this font will
be saved to disk. The saber will then enter the Saber
Configuration menu.
Main Button
MAIN+/-
Hold/Unlatch
+ hold Aux
button
If the aux is held when the main is held or unlatched, then the
values will not be saved to disk, and the saber will enter the
Saber Configuration menu.
7.
THANKS
Special thanks to everyone that has supported me on this journey. It is the community support that makes this
worthwhile and gives me the passion to continue.
Godspeed, and MTFBWY!