Page | 26
Figure 20 – Audio settings tab to set when the hum starts mixing in and for the volume.
5.5.5.
MOTION
The motion tab contains a few simple settings for the on-board motion detection of swings. Use the thresholds to
set how easy/hard of a swing is required to register a swing and slash sound respectively. The swngWait is used to
set the swing sensitivity; lower values allow for quicker swings but can produce two swing sounds for one really
long swing; higher values will always make one swing sound but really quick swings may be missed. Recommended
is 300-500ms.
5.5.6.
ADVANCED
The Advanced tab is used to help adjust the mix of colors for an LED, specifically for LEDs like the X4 where one
color is doubled up. For these LEDs where one color is stronger than the others, they may cause separation during
the retraction effect. To fix this, use these sliders.
For example, if a red and green mix is getting redder near the end of the retraction, then the red needs to be
turned down. This is true for the other colors as well; if any mix of two colors turns more towards one color then it
needs to be turned down a bit. If a value is already below 15 then it may be that the other two need to be turned
up.
