Chapter 4 Preparations for Installation
7
If the required installation environment cannot be established / met, refer to our contact information
in advance.
When using this product under special conditions (clean room, equipment for food, medical
equipment, concentrated alkali, high-pressure steam, etc.), refer to our contact information in
advance.
4.2. Preparation of required components
• The following components and materials are required for installing this product. Check the
components/materials and prepare them at each customer’s site.
• If the shape of the actual section differs from the illustration below, refer to the separately provided “Outer
dimensions” drawings and specification sheet.
• Prepare the input gear, motor mounting flange, case installation component, and shaft installation component
that have been designed and manufactured based on the separately provided “External dimensions” drawings,
specification sheet, and catalog.
Fig. 4-1
If O-ring (II) and high-torque seal washer cannot be used, use the liquid sealants.
The actual components may differ from the required components shown in the above illustration,
depending on the customer’s equipment.
O-ring (II)
or liquid sealant
Hexagon socket
head cap screw
Belleville
spring washer
Shaft installation
component
Case installation
component
O-ring (I)
Motor mounting
flange
Oil seal
Hexagon socket
head cap screw
Belleville spring washer
Input gear and
installation
component
Motor
Motor mounting
bolt
Important
Important
Plug for
injecting/draining
grease
Plug for injecting/draining grease
