Nabco GYRO TECH GT-1175, Wiring And Programming Manual

Page: 5 / 31

5 of 31
www.NabcoEntrances.com GT1175 Slide Door Opus Control Wiring and Programming Manual
Rev. 8-11-21 P/N C-00391
SECTION 3.2: Wiring
Item Description
Power Input 100VAC - 130 VAC, AC 50-60 Hz; 3A ( NABCO recommends min. 5A service)
Power for accessories 12VDC; 750mA
Output Rating Transistor Output; 100mA @ 12VDC
Relay Output Rating Mechanical Relay Output; 3A at 110VAC
F1 Fuse 120VAC Power Circuit of Control
SECTION 3.3: General Specifications
Specification Description
Temperature Range -13 degrees to 140 degrees Fahrenheit
Motor Type High voltage, Brushless Motor with Encoder, 115V
Number of Signal Inputs
►
1 x Activation
►
2 x Door Mode
► 2 x Safety ► 1 x Sequential
► 1 x Breakout (stop) ► 3 x Programmable
Number of Outputs
►
1 x Electric Lock Form C Relay
►
2 x Programmable Transistor Outputs
SECTION 3.4: Electrical Specifications
Note: All Wiring Diagrams included within this manual, reflect typical primary and secondary circuits that might be commonly
used. On site wiring may be different from that shown.
Note: NABCO factory utilizes Underwriters Laboratories (UL) recognized component wire, terminals and connector housings to
manufacture all Automatic Door systems.
Table 1
Power Draw Common Accessories
Sensor Part Number Current Consumption
BEA IXIO-DT1 V-00057 200mA
(ea.unit) at 12VDC
Acusensor M A-01306 150mA
Optex i-oneX T V-00746 208mA
Acuzone T V-00745 208mA
Radio Control Receiver 24-11467 50mA
CX33 Logic Relay V-00734 320mA
SECTION 3.5: Output Power Guidelines
TOTAL current draw from the Opus Control must not exceed 0.7A when providing power to:
X
Sensors
X
Modules
X
Accessories
X
Auxiliary Equipment
An auxiliary power supply, (e.g. NABCO Transformer 24 VDC Power Supply, P/N V-00022) must be utilized if TOTAL current draw
exceeds 0.7A.
The Opus Control must Not be used to power: Magnetic Locks nor Electric Locks
To determine if an auxiliary power supply must be used, add the total current draw of all devices. Please refer to the formula below:
Example: An Automatic Door System is to be fitted with the following devices:
2 x Acusensor M @ 150 mA = 300 mA
1 x Cp/RX Radio Control Receiver @ 50 mA = 50 mA
Total = 350 mA
350mA does not exceed total current draw.
An Auxiliary Power Supply does not need to be used.
CAUTION