![background image](http://html2.mh-extra.com/html/nabco/gt-300/gt-300_installation-manual_3087288007.webp)
7 of 38
www.NabcoEntrances.com
GT300-350-8300-8350OpusOverheadConcealedSwingDoorInstallationManual
Rev 5-23-18
P/N C-00175
DN 0463
Base Plate
Front Side of Header
#10-24 x 3/4”
Phillips Head Screw
Snap In Dress Channel
Dress Plate
Bo om Lock Cover Plate
Snap In Channel Pivot
(Finger Guard or No Finger Guard)
Figure 1 Open Bottom Load Header
SECTION 5 .2: Install the Panic Latch (Inswing Doors only)
X
During Automatic Operation: the Inswing door opens to the Interior side of the building/room. The Panic Latch is
then used as a Door Stop.
X
During Emergency Operation: the Inswing door is manually pushed Out to the exterior side of the building/
room (not to exceed 50 pounds of pressure; per ANSI code). The Panic Latch flips to allow emergency egress and
immediately shuts the Swing door OFF.
Figure 2 Panic Latch during Automatic Operation (Panic Latch acts as Door Stop)
DN 0466
Panic Latch
(In Automa c Posi on)
EXTERIOR
INTERIOR
INSWING
1. Obtain the Panic Latch. Remove (4) Socket Head Cap Screws and (4) Washers. Set aside.
2. Turn the Panic Latch so the (EXT→) (exit arrow) points to the Exterior side of the Building. Failure to do so, will install the
Panic Latch backwards.
DN 0316
EX
T
Back of Panic Latch
(EXT→ must point to
Exterior side of Building)
Panic
Latch
Screws
Washers
Strike Side
of Header
Figure 3 Install the Panic Latch