10 of 38
GT 300-350-8300-8350 Opus Overhead Concealed Swing Door Installation Manual
www.NabcoEntrances.com
P/N C-00175
Rev 5-23-18
Figure 10 Anchor Placement
DN 0402
36” max
48” max
48” max
Y
Y
Y
Y
Y
Y
Note: It is recommended to countersink holes as required to flush the surface.
Note: It is recommended to drill tap threads for anchors in a steel or aluminum structure.
4. Secure the Frame with Fasteners not provided by NABCO.
Figure 11 Screw Anchors
DN 0658
1/4” Fasteners
1/4” Anchor Hole(s)
SECTION 5 .7: Install the Finger Guard
Note: Screws must be appropriate for the type of structure being fastened into. Screws are not provided by NABCO.
Note: Do not overtighten screws to prevent deforming Weatherstrip Extrusion. Ensure each screw is flush to the Jamb tube.
1. Go to the top of the Pivot Jamb tube, at the center, drop a Plumb Line to the floor.
2. Mark the Center line on the inside face of the Pivot Jamb Tube. It is recommended to use a level.
3. Insert the Weather Strip into both channels located on the Finger Guard Mounting Plate.
a. Spraying silicone (not included) inside the Channels may ease the insertion of the Weather Strip.
Figure 12 Install Weather Strip onto Finger Guard Mounting Plate
DN 0470
Weather Strip
Channels
Weather Strip
Channels
Finger Guard Moun ng Plate
SIDE VIEW
Assembled Finger Guard
4. Line up the Center Notch located down the full length of the Finger Guard Mounting Plate, with the Center Mark located on
the Pivot Jamb Tube. It is recommended to use a level.
