![background image](http://html2.mh-extra.com/html/nabco/gt-300/gt-300_installation-manual_3087288017.webp)
17 of 38
www.NabcoEntrances.com
GT300-350-8300-8350OpusOverheadConcealedSwingDoorInstallationManual
Rev 5-23-18
P/N C-00175
DN 1055
Outswing
Arm Moun ng Bracket
Threshold
INSWING
LEFT HAND
Threshold
Inswing Track
EXTERIOR SIDE OF DOOR
INSWING
RIGHT HAND
OUTSWING
RIGHT HAND
OUTSWING
LEFT HAND
Figure 29 Open the Fold Door
X
If the Swing Arm does not swing underneath the Threshold to open, it is an Inswing Unit, and vice versa.
SECTION 8 .2: Install the Handing Harness (for Right Handed Units only)
1. Obtain the Handing Harness. Connect the (Break Module Harness) Female Pin to the Male Pin Housing (Handing Harness)
2. Connect the (Break Module Harness) Male Pin Housing to the Female Pin (Handing Harness).
DN 1345
MOTOR
OPUS CONTROL
BREAK MODULE
HARNESS
MOTOR HARNESS
HANDING HARNESS
MOTOR CONNECTOR
14
13
12
11
10
9
8
7
6
5
4
3
2
1
2
1
1
2
2
1
1
2
2
1
1
2
2
1
Figure 30 Connect the Handing Harness
CHAPTER 9: INSTALL THE FLOOR PIVOT
1. Obtain the Floor Pivot Assembly. The Pivot Shaft is not centered on the Floor Pivot. One end is used:
X
With the Finger Guard; so the Pivot Shaft measures 3.75 inches away from the Pivot Jamb.
X
Without the Finger Guard; so the Pivot Shaft measures 2.75 inches away from the Pivot Jamb.
DN 0484
3.75 inches
2.75 inches
2.75 inches
3.75 inches
Pivot Jamb
Floor Pivot
WITH FINGERGUARD
WITHOUT FINGERGUARD
Figure 31 Position Floor Pivot according to Finger Guard Installation
2. Mark the center of the Pivot Jamb and the Floor Pivot. Butt the center mark of the Floor Pivot up against the center mark of
the Pivot Jamb.
3. Align both Pivot Shafts. Drop a Plumb Line (down the center) from the Top Pivot Shaft to the Floor Pivot Shaft.
4. Use the Floor Pivot as a template to mark and drill (2) holes for #14 x 1 inch Blue anchors provided by NABCO.
5. Insert (2) #14 x 1” Blue anchors into each hole. Secure the Floor Pivot with (2) #14 x 1-1/2 inch Slotted Flat Head Screws.
DN 0486
Pivot Sha
#14 x 1-1/2”
Slo ed Flat Screw
#14 x 1” Anchor
Pivot Jamb
(Center Mark)
Floor Pivot
(Center Mark)
Figure 32 Install Floor Pivot