95
x
Slitter Position
1. Objective
Adjusting the position of each slitter.
2. How to make adjustments
q
Prepare some paper that is either 8
1
/
2
” x 11”, A4
size, or use the adjustment sheet.
w
Turn on the power.
e
Select P-75. Turn off both bar code and reg. mark.
NOTE :
• Use a JOB that has the LEFT. SL set to 10.0
mm and the RIGHT. SL set to 270.0 mm when
the preset program P-75 have been
overwitten.
\
See page 155
r
Run one sheet of paper, and measure the width of the
left margin. If the margin is within a range of 10.0
mm +/- 0.762 mm, go to Step
i
. If it is not in that
range, go to Step
t
to make adjustments.
t
Access H-24.
HELP mode H-24
\
see p.147
y
Adjust H-24 so that the width of the left margin is
within a range of 10.0 mm +/- 0.762 mm.
• Increase the numbers to make the width of the left
margin larger.
• Decrease the numbers to make the width of the left
margin smaller.
u
Repeat Steps
r
to
y
until the width of the left
margin is within the correct range.
i
Run one sheet of paper and measure the width of the
piece of paper that comes out in the exit tray. If the
width is within a range of 260.0 mm +/- 0.762 mm
go to Step
!2
. If it is not in that range go to Step
o
,
to make adjustments.
Left Margin Slitter
Right Margin Slitter
Left Center Slitter
Right Center Slitter
Optional Slitter1
Optional Slitter2
∗
100 100 100
100 100 100
x
Slitter Position
Chap.4
Summary of Contents for DC-545HC
