MyBinding DC-545HC, Service Manual

Page: 37 / 175

34
Cutter
Cutter Motor
Cutter Position
Switch
v
Guillotine Cutter Unit
1. Description
The paper is cut vertically in relation to the direction the
paper is moving.
Turning on the power starts the cutter motor in standby
in the home position.
One cut can be done in approximately 0.3 seconds.
2. Operation
1) Main transfer stops temporarily when the paper
reaches the cutting position.
2) The cutter motor starts and cutting begins.
3) The cutter motor stops when the cutter position
sensor goes from off to on, and the main transfer
starts again. If the cutter position sensor does not
change (if its on then it stays on) 0.6 seconds after
the cutter motor starts running, then J7: CUTTER
LOCK is displayed and the machine stops.
\
See page 134
Circuit diagram
Chap.2
v
Guillotine Cutter Unit
CN6-5
-6 -7 -8
RED BLACK
RED BLACK
YELLOW YELLOW
YELLOW
YELLOW
YELLOW
YELLOW
YELLOW
YELLOW
Main P.W.B. unit
N4-V300*
COVER SW
N4-W120*
COVER SW
N4-W119*
CUTTER UNIT
L8-X109*
CUTTER M.
POSITION SW