19
14. OPERATING THE SHOWER
1. Switch on the electrical supply at the pull cord
or wall mounted switch. The power on neon will
illuminate indicating the switch is on.
2. Press the start / stop button for immediate water
flow. This is confirmed with a single audible bleep.
We recommend that you do not stand under the
spray from the shower handset when switching on.
3. Wait until the water has reached a stable warm
temperature.
4. The “Secret ‘til Illuminated” seven segment
display will activate and show through the front
cover displaying the last temperature selected
from the previous shower (the in built memory
is programmed to remember the last setting).
5. The shower outlet temperature will increase until
it reaches this pre determined temperature.
This could take up to 30 seconds if the shower is
starting from Cold.
NOTE: The seven segment numerical display
indicates the shower outlet temperature where 0 is
cold, digit 1 represents a nominal 30 °C and digit 9
represents a nominal 47 °C.
NOTE: The average showering temperature is 40 °C.
This corresponds to digit 6 on the numerical display.
The outlet water temperature will stabilise and the
unit will control the temperature thermostatically
during the shower.
TO INCREASE THE TEMPERATURE
1. Press the warmer (+) button ONCE. The digit will
move, for example from 6 to 7 confirmed by a single
audible bleep. The water temperature will increase
by a nominal 2 °C. Wait approximately 30 seconds
for the shower to increase the temperature to the
new setting.
2. Repeat this if necessary to achieve your ideal
temperature setting waiting each time for the
new temperature to be achieved.
IMPORTANT: For safety the maximum outlet
temperature of this shower is limited by the
thermostatic control to a nominal 47 °C.
TO dECREASE THE TEMPERATURE
1. Press the cooler (-) button ONCE. The digit will
move, for example from 6 to 5 confirmed by a single
audible bleep. The water temperature will decrease
by a nominal 2 °C. Wait approximately 30 seconds
for the shower to reduce the temperature to the
new setting.
2. Repeat this if necessary to achieve your ideal
temperature setting waiting each time for the
new temperature to be achieved.
FLOW CONTROL AdJUSTMENT
The flow control allows the water flow through the
shower to be reduced or increased. Once the flow
control has been set only occasional fine tuning will
be required
IMPORTANT: If a very high flow is set and the unit
cannot reach the temperature selected the seven
segment display will continue to blink at the rate of
once every 3 seconds. You will need to reduce the
flow rate in stages until the digit stops blinking and
the shower has reached the requested temperature
remembering to wait between each selection for the
shower to respond. Alternatively a lower temperature
could be selected via the cooler (-) push button.
IMPORTANT: Always use the start / stop button to
switch the shower OFF. If the pull cord or surface
mounted isolator is used to stop the shower without
first pressing the start / stop button then you will by-
pass the phased shut down mechanism.
Finally switch OFF at the pull cord or wall mounted
isolating switch.
Summary of Contents for Thermo Response QI
Page 27: ...27 Notes...
