MUTOH Viper TX Softsign, User Manual

Page: 180 / 196

User’s Guide Viper TX Softsign
Troubleshooting
180 AP-75360 - Revision 1.2
The printer does not work after fabric has been loaded
The printer does not work after data has been sent from a computer
The printer does not print
N° Possible cause Solution(s)
ï
The front cover is open Close the front cover
î
You did not load the fabric in a straight line
into the printer
Load the fabric in a straight line into the
printer
Refer to
í
One or more ink cassettes are not installed
Install (an) ink cassette(s)
Refer to
λ°´¿½·²¹ ¬¸» ·²µ ½¿--»¬¬»- ±²
ì
You used the printer in direct sunlight or
inappropriate circumstances
Use the printer in the specified environment
Refer to
ײ-¬¿´´¿¬·±² »²ª·®±²³»²¬ ±²
ë
The head is crashed against a Fabric retainer,
an Y axis current error is generated
The Fabric retainers must be positioned in the
gutter in such a way that the head carriage
cannot run into them
N° Possible cause Solution(s)
ï
You did not connect the interface cable
Connect the interface cables
Refer to
î
One or more ink cassettes are not installed
Install (an) ink cassette(s)
Refer to
λ°´¿½·²¹ ¬¸» ·²µ ½¿--»¬¬»- ±²
í
Ink cassette is empty
Replace the ink cassette
Refer to
λ°´¿½·²¹ ¬¸» ·²µ ½¿--»¬¬»- ±²
N° Possible cause Solution(s)
ï
The model setting of the computer is not
correct
Make sure that the model settings on
computer and printer are the same
î
The interface setting or command mode on
computer and printer do not match