Roll systems – Maintenance Manual
43
AP-74100, Rev. 2.0, 12/01/05
Step 5 :
Rotate (“downwards”) the adjustment lip carefully until the stop sensor is covered. (For the
adjustment direction, please refer to the section “Sensor disc and adjustment direction”.)
¾
The “Automatic” LED will stop blinking.
¾
The rear motor will stop turning.
1 = Rear stop adjustment direction
2 = Rear start adjustment direction
3 = Front stop adjustment direction
4 = Front start adjustment direction
Step 6 :
Tighten the stop screw on the adjustment lip.
4.1.3.2. Adjust the start sensor
Step 1 :
Make sure that the start sensor is not covered and the “Automatic” switch is set to “Manual”.
(Switch in the up position.)
Step 2 :
Hold (or ask someone to hold) the rear tensioning system in an approx. 30° position. (Please
refer to the section “Start sensor system”.)
Step 3 :
Switch the Rear to AUTOMATIC. (Toggle the switch down.)
¾
The “Automatic” LED will start blinking.
¾
The rear motor will start turning at the initial speed (very low!).
Summary of Contents for Unwinder
