5
STEP 3 – SUIT LENGTH
Based on your height, determine your suit length according to the
chart below.
HEIGHT
XS
S
M
L1
L2
XL
XXL
3XL
Short
57-60"
61-64"
65-68"
66-69"
68-71"
70-73"
72-75"
72-75"
Regular
60-63"
64-67"
68-71"
69-72"
71-74"
73-76"
75-78"
75-78"
Long
63/-
66/"
67/-
70/"
71/-
74/"
72/-
75/"
74/-
77/"
76/-
79/"
78/-
81/"
78/-
81/"
Following Steps 1 - 3 should bring you to one comprehensive size such
as L1 Short or Medium Regular, which is a combination of your overall
measurements (chest, waist, etc.) and your height.
*Please note: If all your measurement DO NOT fall into the range
of two sequential sizes, for example, chest measurement is Medium
but Waist measurement is in L2, you may require a full customized
suit. Please contact your Mustang Survival Representative for more
information.
INSTRUCTIONS FOR USE
This manual supplies instructional, maintenance and safety
information for the MSD660, Aviation Rescue Swimmer’s Dry Suit.
NECK SEALS AND WRIST FITTING
The Rubber Neck Seals and Wrist Seals may be trimmed at the initial
fitting, but the seals tend to adjust to the wearer after a short period
of time. If no excessive seal restriction exists, and seal fit is acceptable
to the user, the seals should be left as is. Neck seals shall fit snugly
and remain in direct contact with the neck through all normal head
movements. Wrist seals shall fit tightly enough to prevent water entry,
but not tight enough to restrict blood flow. If seal sizing is required,
proceed as follows:
CAUTION: Trim neck seals with extreme caution. A
smooth trim line is essential. Excessive or careless
trimming could result in loose seals that leak and
necessitate replacement. Avoid nicking seal fabric, as
this could result in tearing the seals when donning and
doffing, and also could result in skin irritation.
1. If neck seal trimming is necessary, mark a line around
circumference of neck opening. Trimming increments shall not
exceed 1/4 inch at a time.
