16
3. Flatten out wrinkles around the perimeter of the neck seal
attachment area. Make sure there are no materials caught
between the circle jig and the neck seal.
4. Pick a point on the neck seal as a starting point and heat until
adhesive has softened, approximately 15 seconds. See Figure 20.
Figure 19
Figure 20
5. Grab neck seal and pull the neck seal away from the suit using
only light force. The neck seal will separate from the suit in the
area that was heated. Gloves may help as the neck seal will be
hot where contacted by the iron. See Figure 21.
CAUTION: Stop pulling the neck seal away from the
suit when resistance is encountered.
6. Continue to heat an adjacent section of the neck seal for 15
seconds.
7. Lightly pull the neck seal to detach the adjacent section.
8. Repeat steps 6-7 until the old neck seal has been removed.
9. Remove the circle jig from the suit when finished.
Figure 21
Figure 22