RoadRunner
U S E R S G U I D E
23
This command is used when a
RoadRunner
is connected to a digital
PBX. If the TA101 is directly connected to an NT1, then the sub-address
should be set to 0. Subaddresses are generally not used in North
America. In Germany, when using the 1TR6 switch type, subadresses
are required. Use the
CSA
command to set the EAZ sub address.
The
CTF
command,
<TA101><Setup><I/F>
sets the interface mode of the internal TA101.
For North American
operation with the TA101, the mode should always be set to
IGNORE
. For operation elsewhere, initially start with the mode set to
IGNORE. If you have problems making or receiving calls, then set the
mode to ACTIVE.
Reset
After the above parameters have been set, it is necessary to reset the
TA101 Terminal Adapter. The
CTR
command,
<TA101><Setup><Reset>
is used to reset the internal terminal adapter and to check if the SPID
and ID numbers have been entered correctly for North American
operation. The reset process takes from 20 to 40 seconds to complete,
and the response will be flash for 2 seconds on the
top line
of the LCD
display. The following responses are possible:
•
SP1 OK SP2 OK
SPID 1 and SPID 2 initialized properly
•
SP1 OK SP 2 BAD
SPID 1 initialized, SPID 2 did not
•
SP1 BAD SP2 OK
SPID 1 did not initialize, SPID 2 did
•
SP1 BAD SP2 BAD
Both SPIDs did not initialize.
If you require two SPID numbers, and if you get any response other
than the first, your TA101 has not been configured properly and you
will not be able to make or receive calls. If only one, or no SPID
numbers are required, than any response may be OK. Try dialing and
see if you can connect to another codec. If you get a bad response, or
you cannot dial, please refer to the Troubleshooting Section before
calling for assistance.
!
note:
