Murska 1400S2X2, Operating Manual, Page: 24 / 56

23
5. If the tractor stalls or the PTO slips:

Close applicator and water.

Switch off the power and disconnect PTO.

Close grain feeder hatches.

Release pressure on hydraulic rams.

Remove auger well cover and elevator belt cover to clear blockage.

Check and clear the build-up of grain between the rollers and check that no metal or
stones are trapped between the rollers or auger, turn rollers backwards by hand to
clear obstruction.

Check that the flow of feed is not too high.

Check tractor speed is correct in relation to flow.
The machine is now ready for Starting Up
6. The flow of grain stops - the Feeder Belt starts to ”smoke”:

The force feeder is bound in straw.

The force feeder is jammed.

The rollers have stopped turning.

Switch off power and disengage PTO.

Close applicator and water.

Insert the cut-off plate to hopper

Remove the straw, stones etc., clean the protective magnets.

Manually reversing the rollers sometimes clears the obstruction.

Remove the cut-off plate
The machine is now ready for Starting Up
7.
Output is reduced:

PTO speed is not correct

Stones etc. loose objects on top of rollers

Straw wrapped round feeder agitators.

Main drive belt stuck or not adjusted correctly.

Auger/elevator belt worn or tensioning is too loose.

Close grain feeder door.

Close applicator and water.

Switch off power and disengage PTO.

Insert the cut-off plate to hopper

Release tension on hydraulic rams and allow roller to fall back to stops and clear
obstruction.

Open grain feeder doors

Remove grain, stones etc. from rollers and feeder agitators.

Close feeder door.

Remove the cut-off plate. The machine is now ready for Starting Up