Murska 1400S2X2, Operating Manual, Page: 17 / 56

16
ROLLER ADJUSTMENT
1. Release Locking Nuts and release all pressure on Spacer Bolts, from both end of
adjustable rollers.
2. Adjust Roller tension Spring to a reasonable tension by pumping the Hydraulic
Hand Pump (half the maximum pressure, see pressure gauge).
Note: when the pressure / tension of hydraulic ram is fully released, the
transmission gears at the rollers may not be in touch. Pump up the pressure up
carefully and ensure, that the gearwheels gets correctly connected.
3. Wind the Roller Adjusting Crank so that the Roller Adjusting Shaft Arm is
pointing straight down.
4. Finger tighten Spacer Bolts.
5. Tighten Spacer Bolts 1/2 turn clockwise
6. Adjuts the rollers with feeler gauge from both ends. Ensure that distance between
the rollers is same at both ends. Minimum distance is 0,3 mm.
7. Tight the Locking nuts.
8. Carry out this adjusting procedure for both pairs of rollers, one side at a time.

If rollers are allowed to touch, excessive wearing will occur which is not covered
by the warranty.

You may now proceed to the Starting Up routine
Do not operate the machine without all the guards in place and properly secured.