13
© Munters Corporation, July 2021
QM1095r1
Installation Instructions
Chapter 2
Step 8
Insert guard into cone with the eyelets facing you. Install eyelets over (4) Bolts already installed at joints in cone
and fasten with Nut [B]. Secure (8) remaining eyelets using Bolt [A] and Nut [B].
See Figure 8.
Figure 8
Step 7
Find the 2 Guard Sections and line the 2 of them up with the eyelets both facing the same direction. Then
secure the guard sections together by wrapping the wire loop on each guard section around center wire of
opposite guard section.
See Figure 7.
Figure 7
Wire Loop
Bolt [A]
Nut [B]
Previously installed -
Bolt and Nut
Nut [B]