11
© Munters Corporation, July 2021
QM1095r1
Installation Instructions
Chapter 2
Figure 4A
Figure 5A
Bolt [A]
Outer Hole
Step 4
Place all 4 cone sections on a flat surface with tabs from one facing slots of the next.
See Figure 4A.
Curl
up tab end of first cone section and insert tabs up into slots in the next cone section. A mallet may be
needed to seat slots over tabs completely.
See Figure 4B.
Repeat this step until all 4 cone sections are
connected and laying flat.
2.2 Cone Installation
Figure 4B
Step 5A
Fasten each of the joints in the single outer hole using (1) Bolt [A] and Nut [B], with the nut on the side with
the tabs. At the inner pair of holes of each joint fasten using (1) Bolt [A] and Nut [B] with the bolt head on
the side with the tabs.
See Figure 5A.
Nut [B]
Bolt [A]
Inner Hole
Nut [B]
