Multiva Cerex 300 Comfort, Operation And Maintenance Manual

Page: 174 / 187

Machine with dual gearbox
The linear actuator for the fertiliser
remote control is at 0 and not
moving. The fertiliser calibration
has failed and is outside the T-
value limits.
On the Settings screen, select 3.
Factory Setup
→
enter the PIN code 1234
→
select 2. Actuator Setup
→
select CUR as your Line Type
setting
→
select Curve Factors
→
set the T-value manually.
If only “########” is shown on
the line, go to the line by
pressing OK. First enter
“000000” as the value and then
accept it by pressing the OK
button. The value “0.00000”
should now appear on the line.
Repeat the above and enter
“0.40000” as the value.
The middle markers do not work
automatically or in the manual
position.
A new value has been entered for
the fertiliser rate and the linear
actuator has not reached the
target.
On basic models, the seed shaft
has to rotate in order for the linear
actuator to move.
Check the function adjusting of
fertiliser target rate according
to section 7.1.14. Checking the
functioning of the adjusting of
fertiliser target rate.
Operation and maintenance manual
Cerex 300 and Cerex 400 Comfort
1.00
174 (187)