Multiva Cerex 300 Comfort, Operation And Maintenance Manual

Page: 127 / 187

7.1.8. Inspecting the wheel drive clearance
1. Lower the machine to its working position.
Figure. 7.1.8. - 163. Inspecting the wheel drive clearance
2. Check the wheel drive clearance (A).
Measure the clearance between the wheel drive head and lower surface of the
transport wheel. The clearance should be 3-5 mm.
To adjust the clearance, rst loosen the locknut (1).
If the clearance is less than 3 mm, raise the drive wheel by turning the bolt (2)
clockwise.
If the clearance is more than 5 mm, lower the drive wheel by turning the bolt (2)
counterclockwise.
After adjusting, tighten the locknut (1).
7.1.9. Checking the condition of hydraulics
1. Check the tightness of the hydraulic system.
2. If needed, tighten the connections.
3. Make sure that the hoses are intact and have no leaks.
If necessary, contact maintenance.
7.1.10. Checking the condition of electric wires
1. Ensure that the insulation of the wires is not worn and that the wires are visible.
2. Ensure that the insulation of the wires have not melted and have no signs of heating or
burning.
If needed, repair by using tape as additional insulation.
If a wire or leads of the wire are cut, contact maintenance.
7.1.11. Inspecting the towing eye
1. Check that the towing eye is not too worn.
Operation and maintenance manual
1.00 Cerex 300 and Cerex 400 Comfort
127 (187)