3 AT Commands, Result Codes, and S-Registers
MT5634ZPX-PCI
37
I4
Display firmware version for data pump (e.g.,
94
).
I9
Display country code (e.g.,
NA Ver. 1
).
I11
Display Diagnostic Information for the last Modem
Connection (i.e., DSP and Firmware version, Link Type,
Line Speed, Serial Speed, Type of Error Correction/Data
Compression, Number of past Retrains,etc.)
Command:
L
n
Monitor Speaker Volume
Values:
n
= 0, 1, 2, or 3
Default:
2
Description: L0
Select low volume.
L1
Select low volume.
L2
Select medium volume.
L3
Select high volume.
Command:
M
n
Monitor Speaker Mode
Values:
n
= 0, 1, 2, or 3
Default:
1
Description: M0
Speaker always off.
M1
Speaker on until carrier signal detected.
M2
Speaker always on when modem is off-hook.
M3
Speaker on until carrier is detected, except while dialing.
Command:
N
n
Modulation Handshake
Values:
n
= 0 or 1
Default:
1
Description: N0
Modem performs handshake only at communication
standard specified by S37 and the
B
command.
N1
Modem begins handshake at communication standard
specified by S37 and the
B
command. During handshake,
fallback to a lower speed can occur.
Command:
O
Return Online to Data Mode
Values:
0, 1, 3
Default:
None
Description: O0
Exit online command mode and return to data mode.
O1
Issue a retrain and return to online data mode.
O3
Issue a rate renegotiation and return to data mode.
Summary of Contents for MultiModem ZPX MT5634ZPX-PCI Series
