Multitech MultiModem ZPX MT5634ZPX-PCI Series, Owner'S Manual

Page: 30 / 88

Owner’s Manual
30 MT5634ZPX-PCI
9. If you are required to dial 9 to get an outside line, edit the dialing
prefix to include a 9 and a comma, e.g., ATDT9, (the comma
inserts a pause before dialing the next digit).
Similarly, to turn off call waiting for the duration of the call, insert
the disabling code used in your area, e.g., ATDT*70, . If you are
using Windows 95-compliant software, make these changes in the
How I dial from this location box of Dialing Properties .
Note: *70 is used only in the United States.
Remote Configuration
Remote configuration is a network management tool that allows you to
configure modems anywhere in your network from one location. With
password-protected remote configuration, you can issue AT commands
to a remote MT5634ZPX-PCI modem for maintenance or
troubleshooting as if you were on-site.
Basic Procedure
Use these steps for connections established by the local or by the
remoteMulti-Tech modem.
1. Establish a data connection with a remote MT5634ZPX-PCI
modem.
2. Send three remote configuration escape characters followed by
AT and the setup password. Then press ENTER. Example:
%%%ATMTSMODEM<cr> . You have four attempts to enter
the password correctly before being disconnected. If the password
is correct, the remote modem responds with OK .
3. You now can send AT commands to configure the remote modem.
4. When you finish configuring the remote modem, save the new
configuration by typing AT&W0<cr> . Then type ATO<cr> to
exit remote configuration. You can then break the connection in
the normal way.
CAUTION: Hanging up while you are in remote configuration
mode can lock up the remote modem.