61
Chapter 5 - Commands
The H3 Mend is as follows:
COMPOSITE LINK FORMAT COMMANDS
#EOFR - SELECTS RECEIVE END OF FRAME CHARACTER FOR
ASYNC LINK.
#EOFT - SELECTS TRANSMIT END OF FRAME CHARACTER FOR
ASYNC LINK.
$MUXCL - SELECTS INT/EXT CLOCKING OF MUX COMPOSITE
LINK.
$MUXSP - SELECTS SPEED OF MUX COMPOSITE LINK WHEN MUX
CLOCKING IS INTERNAL OR ASYNC LINK IS SELECTED.
#SYNC - SELECTS SYNC COMPOSITE LINK
#ASYNC - SELECTS ASYNC COMPOSITE LINK
For HELP on a specific command, enter "ATH" followed by the command
letter:
EXAMPLE: ATH$MUXCL "ENTER"
The H4 Menu is as follows:
COMPOSITE LINK COMMANDS
#C
CLEAR COMPOSITE STATISTICS
#CLA COMPOSITE LINK ACCESS
#DTR TOGGLE DTR ON THE COMPOSITE LINK
$F
LOAD FACTORY DEFAULTS FOR DSU AND ISCC
#FT
FLUSH TIMER VALUE
$L
LIST COMPOSITE LINK CONFIGURATION
#L
LIST COMPOSITE LINK SETTINGS
R
RESPONSE TIME PRIORITY
#RB
SET AUTO REPORTING BAUD RATE
#RT
SET AUTO REPORTING TIME INTERVAL
Summary of Contents for MMH900
