![background image](http://html.mh-extra.com/html/multiquip/diamond-back-sp3-street-pro/diamond-back-sp3-street-pro_operation-and-parts-manual_1855306040.webp)
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE
39
MQ SP-3035 CONCRETE SAW
If an attempt is made to start the saw with the blade pinched, the starter will suffer damage. If an
attempt is made to use the lift pump to raise the saw to free the blade, the lift motor and front axle
could be damaged. If an attempt is made to lift the saw and blade out of the cut utilizing
equipment such as a loader or back hoe, the saw frame and axle are likely to be damaged.
CAUTION
If the Water System is not drained when the saw is not in use and
temperatures fall below 32˚F, damage may occur to optional water
pumps and/or oil coolers.
Draining the Water System
When low temperatures fall below 32
˚
F:
1.
If the saw is equipped with an optional Water Pump, open the drain petcock on the pump and
allow the pump to drain.
2.
With the engine running, turn the water pump switch on for a few seconds to purge water
remaining inside the pump body.
3.
Tilt the saw up and back, to allow water to drain.
4.
Tilt the saw forward, to allow water to drain again.
If an air compressor is available, blow out the system by applying compressed air to the Water
Inlet
Summary of Contents for Diamond Back SP3 Street Pro
Page 2: ......