![background image](http://html.mh-extra.com/html/multiquip/diamond-back-sp3-street-pro/diamond-back-sp3-street-pro_operation-and-parts-manual_1855306121.webp)
MQ SP-3035 Concrete Saw — Specifications
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE
120
S
PECIFICATIONS
Engine
Wisconsin 35 hp V-4, electronic ignition, remote oil filter and above-frame
remote oil drain
Precleaner
Centrifugal type, self-cleaning
Air Cleaner
Four-stage air filtration, cartridge element w/ safety element
Fuel Tank
5 gallon molded tank, shutoff valve and central drain
Spindle Drive Belt
Single 6-groove premium quality 3V Cross-Section Powerband
Belt Tensioners
Single-point Spindle belt tensioner, self-adjusting rotary belt tensioners
throughout for accessories
Blade Range
14“ to 30“
Max Cut Depth
12.75”
Blade Guard
Extra heavy design, slip-on type, w/quick-disconnect water hoses, usable on
either side, 20“ standard, 16”-20”-26”-30” optional
Spindle Assembly
Fully-enclosed bearings and shaft, oil bath, protected seals, 1-1/2” diameter
Spindle, remote protected oil fill and vent, blade usable on either side.
Blade Flanges
Quick-disconnect, taper-lock, 4.5” diameter collars w/ 24 water spray ports
Blade Flushing
Minimum water usage system, panel-mounted flow control, 24 evenly
distributed water spray ports (12 per blade side)
Blade Control
12-volt hydraulic raise/lower system. Joystick-controlled at the operator’s
panel with plunge and raise buttons located on the control joystick
Blade Depth Stop
Positive, heavy duty design w/ accurate depth gauge
Frame
Heavy gauge laser-cut steel, box design, powder coat finish
Lift Point
Integral balanced single-point lift
Balance
Rear pivot design for quick maneuverability
Handlebars
3-position adjustable with in/out and storage positions, quick locks
Front Wheels
6” x 3”, “no maintenance” precision sealed bearings w/ extra end seals and
seal protectors; no grease points
Rear Wheels
11” x 3”
Drive System
Hydro-Gear hydrostatic powered transaxle drive w/ infinite F-N-R speed
control, central joystick, remote filter. Cable control. Positraction w/ panel-
mounted lever.
Travel Speed
Up to 225 feet per minute
Battery
12 volt, group 26, 425 cold cranking amps
Engine Controls
Twist-lock throttle, choke, back-lit Spindle tach w/hour meter, volt meter, 3-
position ignition switch
Electrical Wiring
Easy service loom
Night Light
Standard, removable, usable either side of saw
Front Pointer
Heavy gauge frame, 6” pointer wheel, tether rope
Rear Pointer
Standard, adjustable
Tools
15/16” blade wrench standard
Unit Dimensions
46” long, 27-3/8” wide, 41” high (handlebars in storage position, w/o blade
collars)
Unit Weight
975 pounds, with oil, no fuel
Summary of Contents for Diamond Back SP3 Street Pro
Page 2: ......