MULTIQUIP Diamond Back SP3 Street Pro, Operation And Parts Manual

Page: 13 / 122

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 12
MQ SP-3035 CONCRETE SAW
General Safety Warnings
WARNING

ALWAYS read, understand, and follow procedures in the Operator’s
Manual before attempting to operate the equipment.

Be sure the operator is familiar with proper safety precautions and
operating techniques before using the saw.

Make sure the operating area is clear before starting the engine.

Maintain this equipment in a safe operating condition at all times

Keep the saw clean. It will work better and last longer

Use proper blades and follow the blade manufacturer’s
recommendations. Match blade rpm (Spindle rpm) to recommended
blade surface feet per minute (SFPM).

Tighten the 5/8” blade-mounting bolt to 100-125 foot-lbs. torque.

Turn engine OFF prior to fueling the saw!

Start engine with the joystick in NEUTRAL to prevent unexpected saw
movement
.

Do not leave saw unattended while engine is running.

Do not start engine on a sloping surface to prevent unexpected loss of
control.

Do not park or leave saw unattended on a slope - the saw can roll when
the engine is OFF. Block the unit when leaving.

If the saw must be parked on a slope, turn it across the angle of the
slope, to prevent accidental downhill movement.

Prior Always store equipment properly when not being used. Equipment
should be stored in a clean, dry location out of the reach of children.
When storing the saw in freezing weather, blow out water lines to
prevent damage to components in the water delivery system.

Prior to service, level the frame surface .

Do not over tighten the Spindle drive belt

Turn on water flow prior to starting the engine, to prevent damage to the
impeller of a belt-driven water pump.

Don’t pollute! Waste oils and other chemicals must be disposed of in a
manner consistent with local and state environmental protection
regulations.