MULTICOM 4 PLUS, Installer Manual, Page: 9 / 29

16 17 Quick Start Guide Quick Start Guide
8� Test Signal Strength & Device
Power up the 4 Plus. The logo LED’s will act
as a GSM/GPRS signal strength indicator
for the network (Active SIM only in Dual SIM
devices). The GSM, GPRS, COMMS and
POWER LED’s should turn solid green once
connected.
For Dual SIM devices, you
must call the Activations
Centre to check the signal
strength on the Inactive SIM.
The signal levels are reported
to the Activations Centre
once upon power up.
Power cycle to conduct a new network survey�
The survey may take up to 60 seconds�
If signal strength is less than 2 bars
(>95dB), you must relocate the device
or install a high-gain antenna� If
one of the SIMs can not meet signal
requirements, the SIM may be disabled
9� Activate the Device
To enable your Multicom 4 Plus on the
network call the Activations Centre. For
commissioning via phone please have the
required information ready.
•
Australia - 1300 603 704
•
International - +61 2 8787 9872
Panel ID (0650XXXXX)