MULTICOM 4 PLUS, Installer Manual, Page: 19 / 29

36 37 Programming Options Programming Options
Contact ID Retry Attempts / Default: 5
DTMF
* 3 2 5 #
How many times to attempt sending a contact
ID message before considering that path to have
failed
PSTN Fault Detection Delay / Default: 60
DTMF * 3 4 6 0 #
How long to wait before detecting PSTN
Communication Fault (60 Seconds default). This
also trips the FAULT Relay (See 38 for relay map).
6HHRSWLRQVIRUHQDEOLQJ&,'QRWLÀFDWLRQ
Relay mapping / Default: 122
DTMF * 3 8 A B C #
ABC, where A = COMM’s fail event, B = Aux alarm
event (Batt + AC), C = External alarm (Zone1-2 and
tamper). Each event can be mapped to:
0 = Not Mapped, 1 = Relay 1, 2 = Relay 2.
Power Fault Detection Delay / Default: 1
DTMF
* 2 9 1 #
Delay before reporting power fault (in minutes)
Default 1 minute. This is mapped to the fault
relays, see 38. See options 39 for enabling CID
QRWLÀFDWLRQ
Zone enable / Disable / Default: 1100
ZONE
1 2 3 4
DTMF * 3 0 X X X X #
To enable zones set to one, to disable set to zero.
Default is zones 1 and 2 enabled, zones 3 and
4 disabled. Zones are 24 hour zones. These are
mapped to fault relays by option 38.
Test report time / Default: 24
DTMF * 3 1 2 4 #
The time between test reports for the Multicom (in
hours), default 24 hours. Independent of the alarm
panel & Multicom system polling. Test reports are
sent via the primary path.