56
5.3
Data Port Configuration
This dialog box allows you to configure the data port. You will be able to
set the parameters required for the successful operation of the port.
Mode Asynchronous/Synchronous
This allows you to set synchronous or asynchronous parameters
required for transferring data between the MultiFRAD and the data port
device. The data port can operate either in Asynchronous (UART) mode
or Synchronous (HDLC) mode. Choose the Mode option that meets
your site requirements. Both data port modes are discussed in the
following sections.
Sync Mode Parameters
The following parameters are modifiable when the device connected to the
data port connector on the back of the MultiFRAD 100-Series is a synchro-
nous device. To change a parameter, click on the option button to be
activated. To change a parameter using a drop down menu, click on the
drop down arrow and a drop down menu displays the new parameters.
Click on the desired parameter.
Speed
The Speed parameter needs to be set to match the speed of the sync device.
When the data port is connected to a synchronous device, the baud rate is
from 300 bps to 56K bps. The default port speed is 56K bps.
Summary of Contents for MultiFRAD 100-Series
