Mod. 6609d-6612d:
Automatic Forms Cutter
13.12.2006
-11-
2.3.4 Paper adjustment with reader from above
(See also 3.3.1.5, parameter k)
If the operator starts an
OMR program
, the paper will not be
aligned on the cutting edge. The optical mark reader
evaluates the OMR marks printed on the paper. When the
Start
button is pressed the first mark is positioned at a reading
head.
Please note: There are two different positions of hte reading
head!
1/6" processing:
The adjustment line (AL) must be visible in the groove of
the reading head (see scetch).
1/8" processing:
The adjustment line (AL) must have 0,6 mm distance to the
reading head. Measure the distance always from the middle
of the reading mark.
Adjusting the reading head: The reading head can be moved
in the feeding direction and sideways by loosen the set screws
.
If the adjustment at the reading head is not suffic ent to bring
the reading mark in the position as described above, the
reading area of the adjustment line must be entered one line
before or below under parameter k), .
2.3.5 Paper adjustment with reader from below
(See also 3.3.1.5, parameter k)
With reading from below the OMR mark cannot be detected
when positioning the paper. So you have to make a p unch in
the paper as below.
The adjustment line
should be
marked by means of punch pliers before
inserting the paper.
The hole
must be punched in the
center of the reading mark.
Please note: There are two different positions of the reading
head!
1/6" processing:
The adjustment line (AL) must be visible in the groove of
the reading head (see scetch).
1/8" processing:
The adjustment line (AL) must have 0,6 mm distancet o the
reading head. Measure the distance always from the middle
of the reading mark or from the middle of the hole.
After pressing the
Start
- button the first reading mark is
positioned at the reading head.
Adjusting the reading head: The reading head can be moved
sideways by the set screw and in the direction of feed by
moving the plate .
If the adjustment at the reading head is
not sufficent to bring the reading mark in the position as
described above, the reading area of the adjustment line must
be entered one line before or below under parameter k), .