attEntIon!!
WHEn You sEE a “ WarnInG!” BE surE to HEED tHE MEssaGE!
tHE InForMatIon contaInED In tHEsE MEssaGEs can saVE Your lIFE!!
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This instruction manual complies with the Treestand Manufacturers Association’s TMS 04 -
Standard Practice for Treestand Instructions
and TMS 02 -
Standard Test Method for Treestand Fall Arrest Systems.
6
D
Sleeved Rail
Supports
Foot Platform
D
D
D
Sleeved Rail
Supports
Cross
Braces
Cross
Brace
Cross
Brace
Center Foot
Platform
Front Foot
Platform
Rear Foot
Platform
B
B
B
B
B
B
B
B
Foot
Platform
Leg Supports
B
B
B
B
B
B
B
B
FIG. 1
stEP 4.
Then connect (4)
rail support braces
to the
sleeved rail
supports
and the
foot platform
using (8) 5/16” x 1 3/4” hex bolts [D],
(16) nylon washers and (8) 5/16” nylock nuts.
notE:
The
cross braces
are
attached to the outside of the
foot platforms
and to the inside of the
sleeved rail supports
(Fig. 4).
stEP 2.
Next, attach the
leg supports
to the
foot
platform
using (8) 1/4” x 2 1/4” hex bolts [B], (16) nylon
washers and (8) 1/4” nylock nuts (Fig. 2).
stEP 1.
Connect the
front
,
center
and
rear foot platforms
using (8) 1/4” x 2 1/4”
hex bolts [B], (16) nylon washers and (8) 1/4” nylock nuts (Fig. 1).
FIG. 2
FIG. 4
E
Sleeved Rail
Supports
Foot Platform
E
E
E
Sleeved Rail
Supports
FIG. 3
WarnInG!
read the WEIGHt rEstrIctIon WarnInG, usaGE InstructIons &
WarnInGs on pages 2-3 prior to assembly of this product! Failure to follow the
instructions on this page and pages 2-3 may result in serious injury or death!
WarnInG!
Do not over tighten the hardware. over tightening can lead to structural
damage and may negatively affect the performance of your stand. Failure to follow these
instructions may result in serious injury or death!
Refer to page 11, for installation instructions.
notE:
All steps
require that you temporarily finger tighten all nuts and bolts
until instructed to tighten. This will insure proper alignment
during assembly.
stEP 3.
Attach the
sleeved rail supports
to the
outer edge of the
foot platform
using the front and
rear most holes, secure using (4) 5/16” x 2 1/4” hex
bolts [E], (8) nylon washers and (4) 5/16” nylock nuts.
notE:
The
sleeved rail supports
are
attached with the welded sleeve to the
top and facing to the center of the
foot
platform
(Fig. 3).
