12.
Remove central screw (1) with sealing ring
(2).
13.
Remove filter bowl (3) with oil filter ele-
ment (4) and O-ring (5).
14.
Insert new oil filter element (4) in filter
bowl (3) with the front face with coil spring
facing upwards.
15.
Position filter bowl (3) with new O-ring (5)
on filter head.
16.
Tighten central screw (1) with new sealing
ring (2) manually.
17.
Use torque wrench to tighten central screw (1) to specified tightening torque .
Name
Size
Type
Lubricant
Value/Standard
Central screw
Tightening torque
40 Nm ±5 Nm
18.
Make sure that threaded vent plug (1) was
tightened to specified tightening torque
(→ Step 5) and that the oil drain hose was
removed (→ Step 11).
Note:
Switching back to the position where both
oil filters are cut in (position a) after oil fil-
ter element replacement must be carried
out slowly. Otherwise, an engine shutdown
may occur.
19.
Slowly cut in the filter with the new filter el-
ement at the three-way cock (2) (position
a).
20.
Replace other oil filters in the same way.
21.
Check oil level (→ Page 95).
100 | Task Description | MS15029/01E 2015-06
TIM-ID: 0000043553 - 002
