MTS Systems Landmark 370 Series, Operation

Page: 59 / 134

Running the Example HCF Test
Landmark™ Test System Operation 59
3. If necessary, select a project.
It is common practice to keep all files in Project1. If you find this acceptable, at the Select
Project window, select Project1 . Otherwise enter your own project name for the project.
Note: The Select Project window will not appear if you selected Project1 as the default
project when you installed the MTS TestSuite application.
4. If necessary, select a controller.
In the Controller Selection window, select the controller for the station that you are using.
Note: This window may not appear in all cases.
5. Select a configuration and parameter set.
Under normal circumstances, you would select a configuration file and parameter set
recommended by the experts in your lab. However, for this example test, select the
Training
config.cfg configuration but do not click OK yet .
Parameter sets are found in the lower left corner of the Open Station window. For this
example test, select the
Hard Specimen Tuning parameter set and click Open . A set of
windows may open based on the last user’s window setup. Minimize any windows that appear
as you will be maximizing them as appropriate.