C and D series mowers
22
10.
Lift the right-hand side “UP2” control lever off of the
tall fulcrum post and out of the control housing.
See Figure 3.14.
11.
Lift the right-hand side “UP1” control lever off of the
short fulcrum post and out of the control housing.
See Figure 3.15.
12.
Use a pair of needle nose pliers to compress and
remove the detent spring from the speed control
actuator. See Figure 3.16.
NOTE:
DO NOT over compress the spring.
Squeeze it only as tight as is necessary to
remove it.
NOTE:
Some early production 2011 mowers may
have a small flat washer tucked between the
flat end of the detent spring and the edge of
the control housing. This is intentional.
r
Figure 3.14
UP 2
Tall post
r
Figure 3.15
UP 1
Short post
Washer
r
Figure 3.16
Speed
control
actuator
Detent spring
