Deck and Transmission
51
11.
The two locating tabs on each side of the rear baffle
must be seated in the slots behind the rear baffle
mounting screws before teh screws are tightened.
See Figure 4.63.
12.
The lip on the rear edge of the lower belt cover needs
to fit into the opening in the rear baffle.
13.
Once properly located, install all six screws that
secure the rear baffle, and tighten them to a torque of
30-40 in-lbs. (3.5-4.5 Nm).
14.
Tighten the lower belt cover screws to a torque of 45-
50 in-lbs. (6-7 Nm).
15.
Assemble the remainder of the drive and control systems by reversing the removal processes covered in the
section of this chapter that applies to them.
•
Install the transmission
•
Install the handlebars and controls
•
Connect the control cables
•
Connect the drive belt
•
Install the wheels
16.
Test run the mower in a safe area. Check all of the safety features, and check the full range of drive speeds
before returning it to service. Do not put an unsafe mower into service.
Figure 4.63
Locating tabs
Lower belt cover lip
Never operate a mower without the rear grass door properly in-place. It is a safety device that
is required by law.
The rear grass door is designed to contain grass clippings and light yard debris. In mulching
mode, it keeps clippings under the deck. With the rear grass collector in place, it locks the grass bag
securely in place and prevents
! CAUTION
! CAUTION
