MSA Rail Slider™ Anchorage Connector
4
Safety Regulations
US
1.4
Safety and Precautionary Measures
WARNING!
DO NOT exceed the allowable free fall distance or exceed the maximum fall arrest forces as spec
-
ified by governing standards or subsystem components.
The anchorage to which the MSA Rail Slider Anchorage Connector Strap is attached must be
rated in the direction of intended use. See sections 2.2 "Anchorages and Anchorage Connectors"
and 3 "Use" for details on anchorage strength and loading details.
When installing or removing the MSA Rail Slider Anchorage Connector Strap limit exposure to fall
hazards. A separate independent fall arrest system may be required.
Ensure that fall clearance is sufficient to meet governing standards or subsystem component
requirements.
Prevent swing falls and impact with objects in or adjacent to the fall path. Always remove obstruc
-
tions below the work area to ensure a clear fall path. Keep work area free from debris, obstruc
-
tions, trip hazards, spills or other hazard which could impair the safe operation of the fall protection
system. DO NOT use the MSA Rail Slider Anchorage Connector Strap unless a qualified person
has inspected the workplace and determined that identified hazards can neither be eliminated nor
exposures to them prevented.
Work directly under the anchorage/anchorage connector at all times. A full body harness is the
only acceptable body holding device that can be used in a fall arrest system.
DO NOT rely on feel or sound to verify proper snaphook or carabiner engagement. Ensure that
gate and keeper are closed before use.
If the MSA Rail Slider Anchorage Connector Strap is damaged or is subjected to fall arrest forces
or impact forces, it must be immediately removed from service and marked as "UNUSABLE" until
it has been destroyed.
DO NOT leave the MSA Rail Slider Anchorage Connector Strap installed in environments which
could cause damage or deterioration to the product. Refer to sections 4 "Care, Maintenance and
Storage" and 5 "Inspection" for care and inspection details. Do not leave unattended loads on the
MSA Rail Slider Anchorage Connector Strap.
DO NOT use where lanyard or shock absorber may be exposed to sharp or abrasive edges or
sheared, expanded metal, or frame cut steel. Sharp edges may cut a lanyard or shock absorber
during a fall. Cover all sharp or abrasive edges with padding or sheathing before working above
edge.
Chemical hazards, heat and corrosion may damage the MSA Rail Slider Anchorage Connector
Strap. More frequent inspections are required in these environments.
DO NOT use MSA Rail Slider Anchorage Connector Strap adjacent to moving machinery, elec
-
trical hazards, or in the presence of excessive heat, open flame or molten metal.
DO NOT use fall arrest or rescue equipment in environments with temperatures greater than
130°F (34°C) or temperatures lower than -30°F (-34°C).
DO NOT use the MSA Rail Slider Anchorage Connector Strap near energized equipment or where
contact with high voltage power lines may occur. The metal cable may provide a path for electrical
current to flow, resulting in an electrical shock or electrocution.
Remove any surface contamination such as, but not limited to, concrete, stucco, roofing material,
etc that could accelerate cutting or abrading of attached components.
MSA Rail Slider Anchorage Connector Straps are to be designated and used solely for approved
applications.
Unauthorized alterations, relocations, or additions to the anchorage connector extension are not
permitted.
