Routine Operation
2-4
DRS2000HS/DRS6000HS
User and Technical Manual
POWER Connector
The
POWER
connector provides the AC
input power to the unit. An auto-sense circuit accepts either 110
to 130 VAC or 205 to 240 VAC @ 2 amps.
2.3
Preparing for Operation
The procedures required to operate the DRS2000HS/
DRS6000HS receiver are contained in the following paragraphs.
The color LCD Control menu and the keypad are used to control
all features of the receiver.
2.3.1
Installation
The DRS2000HS/DRS6000HS receiver is typically mounted in a
19-inch (48.3 cm) rack. The unit and cabling are permanently
installed and power comes from facility power.
For additional information, refer to the
“Installation” Chapter on
page 4-1
.
2.3.2
Powering the Receiver
The following paragraphs provide steps to power up and power
down the receiver. If the receiver is installed at an unattended
central receive site, then it typically stays powered up for
extended periods of time.
When the power switch is set to on (
I
), the video monitor will
initially display a blank screen and the Control menu will display
color bars, a logo screen, and finally the Control menu. The
settings displayed when the Control menu is displayed will be the
settings in effect when the unit was last powered down.
Power Up
To power up the receiver, perform the following steps.
1.
Verify that the power cable is connected to the
POWER
connector on the rear panel of the receiver
and is connected to an AC power source.
2.
Verify that all coaxial cables and cable connectors are
properly connected to the front and rear panel
connectors, as required.
3.
Verify that the AC power source is turned on.
Note
When power is set to on in the following step, the
settings displayed will be those in effect when the
receiver was powered down.
If there is no incoming signal, the
RCL
,
SNR
, and
Link Qual
indicators will display their lowest values or
no values.
For a DRS6000HS Receiver with six incoming
signals, the
RCL
,
SNR
, and
Link Qual
indicators
alternate between the
A-B-C-D
inputs and the
E-F
inputs.
4.
Set the power switch on the front panel to on (
I
).
-
The video monitor displays a blank screen.
-
The Control menu goes through a power-up cycle
consisting of color bars, a product ID screen, and
finally the initial Control menu, as shown in
Figure 2-2
on page 2-5
.
Summary of Contents for DRS2000HS
