LITESPEED RX
OWNERS MANUAL
34
Version 2
SAIL REMOVAL
We strongly suggest that you do not attempt this if you are not familiar with this glider.
We recommend that you take the glider to your nearest Moyes dealer for such procedure.
1.
Lay the glider flat on the ground and unzip the glider bag, roll glider so that it is
top-side up, remove all the ties, and spread the wings a few feet.
2.
Remove sail attachment screws from the nose of the glider and rear of keel pocket.
3.
Undo central zipper entirely and remove plastic cable tie at nose of sail.
4.
Disconnect bottom side wires from bottom of down tubes by removing the hinge pin.
Be sure not to lose any of the hardware as the pin is removed.
5.
Disconnect the rear wires from the keel by undoing the Bailey block bolt.
6.
Open the tip zippers and disconnect sail attachment straps from the clevis pins at
the end of each leading edge tip.
7.
Carefully slide frame forward and out of sail.
To re-assemble the glider reverse the order in which it was disassembled.
