LITESPEED RX
OWNERS MANUAL
Version 2
9
3.
Aluminium Rear Leading Edge
Insert the right hand back section of leading edge. The right hand back section
differs from the left in the mounting of the outer sprog. You can check this by
picturing that the cable must be on the top side of the leading edge and the sprog
must fold inboard. Push the back section into the mid sleeve while depressing the
push button pin. Continue to push the back section in until it reaches its stop, then
rotate the back section until the mid sleeve location holes align with the push
button pin. Closely check that the push button pin has fully released and that the
back section is secure against rotation forces.
Picture 3
Insert the back
ends of the
leading edge.
Carbon Rear Leading Edge
a.
Remove the clevis pin and safety ring from the front
leading edge via the inboard dive stick zipper on the
under surface of the right wing.
b.
Access the back end of the aluminium leading edge via
the outboard dive stick zipper. Note the position of the
mid eccentric ring locating screw, as the eccentric ring
must be refitted to the exact same position. Remove
the retention screw and the mid eccentric ring from the
leading edge.
c.
Select the right carbon rear leading edge (RLE). This can be done by
extending the dive strut. The dive strut wire must be on the top of the leading
edge to support the dive stick.
d.
Fit the mid eccentric ring over the carbon rear leading edge.